Selection and move to the next part of the camera setup. Once you have completed setting the time and date, press the SET button to confirm the Set the Date and Time as desired by pressing the RIGHT and LEFT direction control buttons toĬhoose the specific setting and the UP and DOWN buttons to change each setting. The next step in the initial camera setup is to set the date and time on the camera. These settings can be adjusted at any time manually through the menus in the camera. Note: If you select “No” and decide to leave the camera setup, the camera will be set to its default settings. Select “Yes” to continue or “No” to exit the setup. A message will appear: “Continue with Camera Setup?” Then press the SET button to confirm the selection.Ģ) After selecting a language, you will be asked if you would like to continue with the initial camera setup. Select the language of your choice by pressing the UP and DOWN direction control buttons.
Press the POWER button to turn on the camera.ġ) You will first be prompted to select a language for the camera. If the SD card is locked this will prevent the camera from saving captured photos to the SD card. Make sure the SD card is not locked (check the lock switch on the side of the SD card). If you do not see the SD icon on the display, please check if the card was inserted properly. This indicates the SD card has been inserted correctly.Īfter the camera is powered on, an SD icon will appear on the LCD display. Push the SD card until you hear a slight clicking sound. Push the SD card into the slot in the direction shown on the camera (see SD icon by the SD card slot). (SD card not included.) To properly insert the SD Card: Make sure an SD card has been properly inserted into your camera. The energy status of the power is displayed on LCD as shown below: When the battery power is low the battery icon turns red and the camera will automatically turn off a few seconds later. Some features, such as Flash, will not work if the battery power level is low.
Remove the batteries from the camera when not in use for an extended period.ĭo not mix alkaline and non-alkaline batteries. Make sure the batteries have been inserted properly into your digital camera, according to the polarity shown inside the battery compartment. When powering the camera ON for the first time the camera will take you through the INITIAL Transferring Images from my Camera to my Computer Manually. Getting Photos and Videos from your Camera to Your Computer. Ĭamera Technical Specifications.Ĭomputer System Requirements.